Filter
Top Products
© 2004 General Binding Corporation
Spartan Operation and Maintenance Manual
Page 5-2
5.2 Roller pressure handle
The roller pressure handle sets the roller nip opening for
the desired application with the material being used.
INFORMATION: Never attempt to alter the
factory preset settings for the nip opening or speed.
Contact your local service representative if you feel
the roller pressure handle requires calibrating.
Roller release position
– Use this position when the laminator is not in use or no
nip pressure is required. This is the maximum nip opening
position.
Foam pouch position
– Use this position when using board type materials through
the laminator. This nip opening and speed is preset for
GBC materials.
Laminating position
– Use this position when running film pouch type materials.
The is the minimum nip opening position. This nip opening
and speed is preset for GBC materials.
5.3 ON/ OFF power switch
The power ON/ OFF turns your laminator on. When the
laminator is on, the rollers begin heating automatically.
(–) This is the ON position for the laminator.
(O) This is the OFF position for the laminator.
CAUTION: During long periods of no use, 30
minutes or greater, you should turn power off to the
laminator. This will prevent hot spots from forming
on the rollers.