Filter
Top Products
© 2004 General Binding Corporation
Spartan Operation and Maintenance Manual
Page 7-2
1. Set the pressure handle to the roller release position
and raise the cover.
R
E
A
D
Y
U
U
S
G
S
P
R
G
E
A
L
A
M
I
N
A
T
E
O
A
M
P
O
U
C
H
R
E
2. Use a damp ( use water only to dampen the cloth )
white terry cloth towel to wipe dust from the upper roller.
3. For the lower roller, close the cover, press RUN to
rotate the lower roller to a new area to clean.
4. Repeat the steps above until the lower roller is cleaned
7.2.2 Adhesive on rollers
CAUTION: Hardened adhesive deposits on the
rollers can cause damage to the rollers.
CAUTION: Do NOT pick or pull heat activated
adhesive off the rolls when they are cold. You can
cause irreparable damage to the laminating rolls.
CAUTION: The following procedure is performed
while the laminator is HOT! Use extreme caution!
1. Set the pressure handle to the roller release position
and raise the cover.
R
E
A
D
Y
U
U
S
G
S
P
R
G
E
A
L
A
M
I
N
A
T
E
O
A
M
P
O
U
C
H
R
E
2. With a rubber cement eraser or Scotch Brite
TM
gently
rub the adhesive on the roller.
CAUTION: Excessive pressure can destroy the
silicone layer by pressing too hard or scrubbing too
long in one spot.
3. Use a damp (water only) white terry cloth towel to
wipe adhesive beads off the roller.
4. For the lower roller, close the cover, press RUN to
rotate the lower roller to a new area to clean.
5. Repeat the steps above until the lower roller is cleaned