Filter
Top Products
© 2004 General Binding Corporation
Spartan Operation and Maintenance Manual
Page 6-1
6.0 Applications
The Spartan laminator will accommodate GBC mounting
boards and lamination pouches. This section will describe
how each process is run on the laminator.
INFORMATION: The leading edge will always be
the edge which is sealed. The opposite edge is
referred to as the trailing edge.
CAUTION: When changing from one application to
another (example: lamination pouch to pouch
boards), allow the machine to run for approx. 20 min
after setting pressure handle to let the roller
tempurature reach correct operating tempurature.
The top roll sensor only reads the top roll and the
bottom roll may not be the correct tempurature.
6.1 Pouch boards
1.
Turn the laminator on.
2. Center the image on the board under the film.
Image
Film
Board
3. Set the pressure handle to the foam pouch position.
4. Wait for READY to illuminate.
5. Press RUN.
+
6. Align the leading edge of the pouch board slightly off
center of the table.
7. Gently slide the pouch board into the roller nip until
you feel the rollers catch the board.
8. Support the board as it exits the rear of the laminator.
9. Press STOP and set the pressure handle to the roller
release position.
+
10. Peel the clear protective layer off the board and trim
to desired size.
Clear protective layer