Filter
Top Products
© 2004 General Binding Corporation
Spartan Operation and Maintenance Manual
Page 6-2
6.2 Mounting boards
1.
Turn the laminator on.
2. Center the image on the board under the protective
sheet.
Image
Protective sheet
Board
3. Set the pressure handle to the foam pouch position.
4. Wait for READY to illuminate.
5. Press RUN.
+
6. Align the leading edge of the mounting board slightly
off center of the table.
7. Gently slide the mounting board into the roller nip until
you feel the rollers catch the board.
8. Support the board as it exits the rear of the laminator.
9. Press STOP and set the pressure handle to the roller
release position.
+
10. Pull the protective layer off the board and trim to
desired size.
Protective layer