Filter
Top Products
7
CONNECTING AND OPERATING
THE GEFENTOOLBOX 4X1 SWITCHER FOR HDMI
Example 2: Routing Input (source) 3 to the Output (display).
1. Using Fig 1.1 (page 6) as a starting point.
2. Press the Input Select button once.
Fig 1.2
The row of LED indicators will now appear as in Fig 1.2. LED #2 will turn off and
LED #3 will become enabled, indicating that Input 3 is being routed to the Output
(display).
Automatic Switching
The GefenToolBox 4x1 Switcher for HDMI features Automatic Switching. When
a connected source is powered ON, the GefenToolBox 4x1 Switcher for HDMI
will automatically switch to that input. If the same device is powered-down, the
GefenToolBox 4x1 Switcher for HDMI will revert to the (original) active source.
The Switcher will always change to the last source device that was powered ON.
Automatic Switching can be enabled or disabled through RS-232. See page 14
for the command syntax.
NOTE: The IR Remote Control unit, RS-232, and the front-panel buttons will
always allow manual switching of source devices, even if Automatic Switching is
enabled.