Filter
Top Products
- 50 -GA-8PE667 Ultra2 / Pro Motherboard
English
))
))
)ACPI Suspend Type
S1(POS) Set ACPI Suspend Type to S1/POS (Power On Suspend). (Default value)
S3(STR) Set ACPI Suspend Type to S3/STR (Suspend To RAM).
))
))
)Power LED in S1 State
Blinking In standby mode(S1), power LED will blink. (Default Value)
Dual/Of f In standby mode(S1):
a. If use single color LED, power LED will turn off.
b. If use dual color LED, power LED will turn to another color.
))
))
)Soft-off by PWR-BTTN
Instant-of f Press power button then Power of f instantly. (Default value)
Delay 4 Sec. Press power button 4 sec to Power of f. Enter suspend if button is pressed less
than 4 sec.
))
))
)PME Event Wake up
0 When set at Enabled, any PCI-PM event awakes the system from a PCI-PM controlled
state.
0
This feature requires an ATX power supply that provides at least 1A on the +5VSB
lead.
Disabled Disabled PME Event Wake up function.
Enabled Enabled PME Event Wake up function. (Default Value)
))
))
)Modem Ring On/ WakeOnLAN (When AC Back Function is set to [Soft-Off])
0 You can enable wake on LAN feature by the "ModemRingOn/WakeOnLAN" or "PME Event Wake
up" when the M/B has "WOL" onboard connector. Only enabled the feature by "PME Event Wake
up".
0 An incoming call via modem awakes the system from its soft-of f mode.
0 When set at Enabled, an input signal comes from the other client/server on the LAN awaks the
system from a soft of f state if connected over LAN.
Disabled Disabled Modem Ring On / Wake On LAN function.
Enabled Enabled Modem Ring On / Wake On LAN function. (Default Value)