Filter
Top Products
Chapter 2: Installation
14 GE-DS-242-PoE Managed Ethernet Switch User Manual
• System
LED Color Function
PWR Green Lit: indicates there is power to the Switch
• Per 10/100Base-TX, PoE interfaces (Port-1 to Port-24)
LED Color Function
LNK/ACT Green
Lit: indicates the link through that port is successfully
established
Blink: indicares the Switch is actively sending or receiving data
over that port
PoE In Use Orange
Lit: indicates the port is providing 48VDC in-line power
Off: indicates the connected device is not a PoE Powered
Device (PD)
• Per 10/100/1000Base-T port/SFP interfaces
LED Color Function
LNK/ACT 1000 Green
Lit: indicates the port is operating at 1000Mbps
Off: indicates the port is operating at 10Mbps or 100Mbps
Blink: indicates the Switch is actively sending or receiving data
over that port
LNK/ACT 100 Green
Lit: indicates the port is operating at 100Mbps
Off: indicates the port is operating at 10Mbps or 1000Mbps
Blink: indicates the Switch is actively sending or receiving data
over that port
NOTE:
1. Press the RESET button once. The Switch will reboot automatically.
2. Press the RESET button for about 10 seconds. The Switch will revert to the factory
default mode; the entire configuration will be erased.
3. The 2 Gigabit TP/SFP combo ports are shared with port 25/26 of GE-DS-242-PoE.
Both of them can operate at the same time.