Filter
Top Products
Chapter 2: Installation
18 GE-DS-242-PoE Managed Ethernet Switch User Manual
Step 6: Follow steps 4 and 5 of the Desktop Installation section to connect the
network cabling and supply power to the Managed Switch.
SFP Transceiver Installation
This section describes how to insert an SFP transceiver into an SFP slot.
SFP transceivers are hot pluggable and hot swappable. You can insert and remove a
transceiver to and from any SFP port without powering down the Managed Switch, as
shown in Figure 2-7.
Figure 2-7: Plugging-in the SFP transceiver
Approved GE Security SFP Transceivers
The Managed Switch supports both single-mode and multi-mode SFP transceivers.
The following list of approved GE Security SFP transceivers is correct at the time of
publication:
1000Base-SX/LX SFP transceiver:
• SFP1000SX-220 SFP (1000BASE-SX SFP transceiver - Multi mode / 220m)
• SFP1000LX-10Km SFP (1000BASE-LX SFP transceiver - Single Mode / 10km)
NOTE: It is recommended that only approved GE Security SFP transceivers be used on
the Managed Switch. If you insert an SFP transceiver that is not supported, the Switch
will not recognize it.