Filter
Top Products
IMAGETEAM™ 2020/5620 System Manual 1 - 9
Changing Scanner Name - via Bar Codes
If you wanted set up your scanners with names 0001-0007, you may scan the
bar codes below.
Scan the Reset bar code after each name change and wait for
the scanner to re-link to the base before scanning the next bar code to name the
next scanner.
Alternatively, you may change the name with a bar code command if you cannot
send serial commands to the base. One way to do this is to scan the bar code
below and scan a number for the scanner name. For example, if you had 7
scanners to one base, scan the bar code below with the first scanner, scan the
1 bar code on the Programming Chart inside the back cover of this manual and
scan Save. Then scan the Reset bar code and wait for the scanner to re-link to
the base before scanning the next bar code. Repeat that process for scanner
number 2 , 3, 4 etc.
If you want to assign an alphabetic name to the scanner, create a Code 128 bar
code containing “~BT_NAM
name
.” followed by a FNC3 character (hexidecimal
83), where
name
is the new scanner name. Scan the Reset bar code (page 1-9
or on the Programming Chart inside the back cover of this manual). You may
use Barcode Builder, which is included with Quick*View. You may download
Quick*View from the Hand Held Products website: www.handheld.com
.
0001
0002
0003
0005
0007
0004
0006
Reset
0002
Scanner Name