Filter
Top Products
3 - 10 4600rp, 4600g/4600r, 4800i User’s Guide
Note: This setting does not affect the aimer light. The aiming light can be set
using Aimer Mode (page 3-11).
Imager Time-Out
Imager Time-Out powers down the imager after the unit has been idle for the
specified time. To prevent the imager from powering down, set this time-out to
0. Scan the barcode below, then set the time-out by scanning digits (from 0 -
999,999 ms) from the inside back cover, then scanning
Save
.
Default = 60,000
ms.
Note: The default applies to firmware with a base number of 31205480. Refer
to the Show Software Revision on page 11-2 for information on
determining the firmware revision in your unit.
Aimer Delay
The aimer delay allows a delay time for the operator to aim the imager before the
picture is taken. Use these codes to set the time between when the trigger is
pulled and when the picture is taken. During the delay time, the aiming light will
appear, but the LEDs won’t turn on until the delay time is over.
Lights Off
* Lights On
Imager Time-Out
400 milliseconds
* Off
(no delay)
200 milliseconds