Hasbro 75052 Projector User Manual


 
Product and colors may vary.
© 2005 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
75052 PN 6515800000
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on the circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
TROUBLESHOOTING GUIDE
START UP PROBLEMS
If no lights or sounds turn on:
Be sure that the power cord is securely connected to
the projector and the other end is plugged into an
outlet with power.
Be sure the lens cap is off.
Press the On/Off button again.
Unplug the power cord for 15 seconds, then plug it
in and press the On/Off button again.
Be sure volume is turned up.
PICTURE PROBLEMS
If the image is out of focus:
When displaying the main menu, adjust the manual
focus.
Ensure the projection surface is between 4 and 8
feet away from the projector.
Check the projection lens to see if it needs cleaning.
If the image is too small or too large:
Move the projector closer to or farther from the
viewing surface.
If the projector colors seem slightly wrong:
Go to the main menu and try adjusting the Color,
Tint, Brightness and Contrast of the picture.
INTERRUPTION PROBLEMS
If the projector stops responding to all controls:
If possible, turn off the projector, then unplug the
power cord and wait at least 15 seconds before
reconnecting power.
If the lamp shuts off during a show:
A minor power surge might cause the lamp to shut
off. This is normal. Wait a few minutes, then power
on the projector.