Hasbro 75052 Projector User Manual


 
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with a dry cloth.
Do not block any ventilation openings. Install in
accordance with the manfacturer’s instructions.
Do not install near any heat sources such as
radiators, heat registers, stoves or other apparatus
(including amplifiers) that produce heat.
Do not defeat the safety purpose of the polarized
or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or third grounding prong are
provided for your safety. If the provided plug does
not fit into your outlet, consult an electrician for
replacement of the obsolete outlet
Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the
apparatus.
Only use attachments/accessories specified by the
manufacturer.
Use only with the stand provided with the
apparatus.
IMPORTANT SAFETY INSTRUCTIONS
Unplug this apparatus during lightning storms or
when unused for long periods of time.
Refer all servicing to qualified personnel. Servicing
is required when the apparatus has been damaged
in any way, such as power supply cord is damaged,
liquid has been spilled or objects have fallen into
the apparatus, the apparatus has been exposed to
rain or moisture, does not operate normally, or has
been dropped.
If servicing is required, please contact Hasbro
Consumer Affairs at 1-800-844-3733.
Do not look directly into the lens when the lamp
is on.
Keep plastic, paper, and combustible material at
least 0.5 m (2 ft.) away from the projector lens
and vents.
Do not put anything on top of the projector.
Use only enclosed power cord rated for the voltage
and current marked on the product label.
Do not stand the projector on its front surface.
Do not touch the lens with your fingers. See
“Cleaning the projector lens” on page 13.
Do not open the projector except as instructed by
this guide on page 14 and only after allowing the
projector to cool down.
Warnings and power rating information are located
inside DVD compartment and on the bottom panel.
Place the projector on the table top and open
environment when it is operating.
2