Filter
Top Products
Installing and Starting the HP-UX AAA Server
Testing the Installation
Chapter 2 23
Testing the Installation
To quickly test the server installation, you will use Server Manager to add a loopback
connection to a AAA server, start the server, and then check its status for a response. Use the
following steps to test the server installation:
Step 1. Connect to Server Manager and start the AAA server. See “Starting the HP-UX
AAA Server” on page 22.
Step 2. Select the Server Connections link from the Navigation Tree and then select the
Connect to Server link.
Step 3. Enter the values for your server in the Add Connection screen that appears and
select Create:
Name The identifying string of a remote server.
Domain Name or IP Address
The IP address (in dotted-quad notation) or valid Domain Name
System (DNS) host name of the AAA server that the connection
maps to.
Step 4. Verify the server is listed and selected in the Server Status frame.
Step 5. Select the Administration link from the Navigation Tree.
Step 6. Select Start.
Step 7. Verify the server started. A green “GO” icon in the Server Status frame indicates
the server is running.
Step 8. Verify the server is selected in the Server Status frame and then select the Status
option.
Step 9. Check Server Manager’s Message Frame for the status reply. The following reply at
the bottom of the Message Frame indicates the server is running correctly:
“<server name> (port#)” is responding
NOTE If you did not receive this message, refer to the Troubleshooting
chapter in HP-UX AAA Server Administrator’s.