Filter
Top Products
03
LAN ERROR-
EXTERNAL
LOOPBACK
The print server is incorrectly connected to your network or is defective.
Make sure your print server is correctly attached to your network. In
addition, check the cabling and connectors.
07
LAN ERROR-
CONTROLLER
CHIP
Check the network connections. If the connections are intact, run the
power-on self-test: turn the printer off, then on again. If the error
persists, replace the print server.
08
LAN ERROR-
INFINITE
DEFERRAL
There is a network congestion problem.
Note: If the print server is not connected to the network, this error
cannot occur.
09
LAN ERROR-
BABBLE
Check the network connections. If the connections are intact, run the
power-on self-test: turn the printer off, then on again. If the error
persists, replace the print server.
0A
LAN ERROR-
NOSQE
Check the network connections. If the connections are intact, run the
power-on self-test: turn the printer off, then on again. If the error
persists, replace the print server.
0C
LAN ERROR-
RECEIVER OFF
There may be a problem with your network cabling or the print server.
Check the cabling and connectors on your Ethernet network. If you
cannot find a problem with your network cabling, run the power-on
self-test: remove and re-attach the power module connector on the print
server. If the error persists, there is a problem with the print server.
0D
LAN ERROR-
TRANSMITTER
OFF
There may be a problem with your network cabling or the print server.
Check the cabling and connectors on your Ethernet network. If you
cannot find a problem with your network cabling, run the power-on
self-test: remove and re-attach the power module connector on the print
server. If the error persists, there is a problem with the print server.
0E
LAN ERROR-
LOSS OF
CARRIER
Check the network connections. If the connections are intact, run the
power-on self-test: remove and re-attach the power module connector
on the print server. If the error persists, replace the print server.
10
LAN ERROR-
UNDERFLOW
There may be a problem with your network cabling or the print server.
Check the cabling and connectors on your network. If you cannot find a
problem with your network cabling, run the power-on self-test: remove
and re-attach the power module connector on the print server. If the
error persists, there is a problem with the print server.
11
LAN ERROR-
RETRY FAULTS
There is a problem with your network cabling or external network
configuration. Verify operation of the hub or switch port.
12
LAN ERROR- NO
LINKBEAT
With a 10Base-T or 100Base-TX port connected, Link Beat is not
sensed. Check the network cable, and verify that the concentrator or hub
is providing Link Beat.