Filter
Top Products
2. Command Summary
2.1 User EXEC Commands
enable
Enters the manager EXEC level. If a manager password is set, the system will first
prompt for the password. Echoing is disabled while you enter the password. Initially
there are no passwords for the two levels of users in the system: manager and
operator. When you first connect to the console or telnet into the system, you will be
placed into the Operator EXEC level. At that time, you can enter the above enable
command without a password in order to be granted manager access to the switch
and to be placed into the manager EXEC level. Passwords are set and changed
through the password command at the global configuration level.
configure [terminal]
Used to enter the global configuration level.
end
This command sets the current command or context level to the manager EXEC
level.
exit
This command sets the current command level to the previous command level. At
the operator EXEC level, this command acts the same as logout.
interface [ethernet] <port-list>
Enters the Ethernet interface configuration context for the port-list.
logout
Terminates this console/telnet session.
menu
Used to enter the menu system. For more information, see the Console Menu
section of this document.
setup
Used to setup initial switch configuration.
5