Filter
Top Products
Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Telnet
For example, to use one command to configure the switch with the following:
■ VT100 operation
■ 19,200 baud
■ No flow control
■ 10-minute inactivity time
■ Critical log events
you would use the following command sequence:
The switch implements the Event Log change immediately. The switch implements
the other console changes after executing
write memory and reload.
Figure 7-3. Example of Executing the Console Command with Multiple Parameters
You can also execute a series of console commands and then save the
configuration and boot the switch. For example:
Configure
the
individual
parameters.
Save the
changes.
Boot the
switch.
Figure 7-4. Example of Executing a Series of Console Commands
7-7