HP (Hewlett-Packard) 2848 Switch User Manual


 
Getting Started
Port Identity Convention for Examples
Screen Simulations
Figures containing simulated screen text and command output look like this:
Figure 1-1. Example of a Figure Showing a Simulated Screen
In some cases, brief command-output sequences appear outside of a num-
bered figure. For example:
HPswitch(config)# ip default-gateway 18.28.152.1/24
HPswitch(config)# vlan 1 ip address 18.28.36.152/24
HPswitch(config)# vlan 1 ip igmp
Port Identity Convention for Examples
This guide describes software applicable to both chassis-based and stackable
HP ProCurve switches. Where port identities are needed in an example, this
guide uses the chassis-based port identity system, such as “A1”, “B3 - B5”, “C7”,
etc. However, unless otherwise noted, such examples apply equally to the
stackable switches, which typically use only numbers, such as “1”, “3-5”, “15”,
etc. for port identities.
Related Publications
Read Me First. The Read Me First shipped with your switch provides soft-
ware update information, product notes, and other information. A printed
copy is shipped with your switch. For the latest version, refer to
“Getting
Documentation From the Web” on page 1-6.
Installation and Getting Started Guide. Use the Installation and Get-
ting Started Guide shipped with your switch to prepare for and perform the
physical installation. This guide also steps you through connecting the switch
to your network and assigning IP addressing, as well as describing the LED
indications for correct operation and trouble analysis. A PDF version of this
guide is also provided on the Product Documentation CD-ROM shipped with
the switch. And you can download a copy from the HP ProCurve website. (See
“Getting Documentation From the Web” on page 1-6.)
1-4