HP (Hewlett-Packard) 2848 Switch User Manual


 
Time Protocols
TimeP: Viewing, Selecting, and Configuring
Use the Space bar to select the Manual mode.
i. Press [>] to move the cursor to the
Server Address field.
ii. Enter the IP address of the TimeP server you want the switch to
use for time synchronization.
Note: This step replaces any previously configured TimeP server
IP address.
iii. Press [>] to move the cursor to the
Poll Interval field, then go to step
6.
6. In the Poll Interval field, enter the time in minutes that you want for a TimeP
Poll Interval.
Press
[Enter] to return to the Actions line, then [S] (for Save) to enter the new
time protocol configuration in both the startup-config and running-config
files.
CLI: Viewing and Configuring TimeP
CLI Commands Described in this Section
show timep
[no] timesync
ip timep
dhcp
manual
server <ip-addr>
interval
no ip timep
page 9-17
page 9-18 ff., 9-20
page 9-18
page 9-19
page 9-19
page 9-20
page 9-21
9-16