Filter
Top Products
Connecting to a Windows NT Server 3.51
Windows for Workgroups Ver. 3.11
Connecting to a Windows NT Server 3.51
Windows for Workgroups
Ver. 3.11
Requirements
• HP Vectra with DOS and MS-Windows for Workgroups 3.11 installed.
• 3COM Etherlink 3C905 Ethernet card and drivers disk ver. 4.3.
• NDIS Driver Name: El90X.386 Size: 72KB Date: 1/29/98
• Microsoft Windows NT Server 3.51 machine that supports Net BEUI,
NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• Network Driver Optimization Normal
• Full Duplex Auto Select (N-WAY)
• Boot PROM Disabled
• Media Type Auto Select (N-WAY)
• I/O Base Address FCC0h (PCI)
• Interrupt Request Level 9 (PCI)
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink III 3C905
adapter card into a PCI slot.
2 Connect network cable media to the 3COM 3C905 card.
3 Power on the machine and set Plug and Play in CMOS to off.
4 After booting, insert the 3COM’s drivers disk “Etherlink 3C905 Ethernet
ver. 4.3”, and execute “A:\3C90XCFG.EXE.”
5 Select “CONFIGURE NIC,” and verify the resource settings listed above
c
905.bk : ch_5.fb4 Page 1 Thursday, October 22, 1998 9:51 AM