Filter
Top Products
4–20 Maintenance and Service Guide
Removal and replacement procedures
Solid-state module
✎
The solid-state module spare part kit includes a solid-state bracket.
Before removing the solid-state module, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the battery (see “Battery” on page 4-7).
5. Remove the following components:
a. Switch cover (see “Switch cover” on page 4-8)
b. Keyboard (see “Keyboard” on page 4-9)
c. Palm rest (see “Palm rest” on page 4-16)
Remove the solid-state module:
1. Remove the two Phillips PM2.0×5.0 screws 1 that secure the solid-state module cover to the computer.
2. Loosen the Phillips PM2.5×11.0 captive screw 2 that secures the solid-state module cover to the computer.
3. Grasp the Mylar tab on the solid-state module, and slide the solid-state module 3 to the right to disconnect it
from the system board.
4. Remove the solid-state module 4.
Description
Spare part
number
■ 2-GB solid-state module 578184-001
■ 1-GB solid-state module 578183-001