Filter
Top Products
Installation 13
Parameter Options Description
CheckSum = Default = ON
Selections are: ON, OFF, Tx,
Rx
Enables or disables the transmit and receive
checksum off-loading feature. Checksum is
supported under NetWare 5.x only. If you
want to enable the CheckSum parameter, you
need to load it on the first instance.
Frame = type Valid types are:
Ethernet_802.2,
Ethernet_802.3, Ethernet_II,
Ethernet_SNAP
Defines the frame type being used by this load
instance. Ethernet_802.2 and Ethernet_II are
the default values.
node = NNNNNNNNNNNN Specifies a node address in this field to
override the default Media Access Controller
(MAC) address (also known as the Locally
Administered Address)
name = text
Displays the name assigned to this adapter
PDriver = Default = OFF
Selections are: OFF, ON
Allows driver to operate in persistent driver
mode. Persistent driver mode is supported
under NetWare 5.x only. Use only if adapter
is placed in a Hot Plug PCI slot and only if
required to swap with an exact board.
RxBuffers = Default = 200
Recommended Min = 32
Max = 512
Min = 1 when used with DOS
Client32 and when Keywrod
P3-1 or 2.
Pre-allocates ECB resources on the adapter for
receiving packets
TxDescriptors = Default = 200
Recommended Min = 100
Max = 512
Min = 1 when
used with DOS
Client32 and when
Keywrod P3-1 or
2.
Pre-allocates ECB resources on the adapter for
transmitting packets.
RxFlow = Default = OFF
Selections are: ON, OFF
Allows enabling/disabling of RxFlow control.
TxFlow = Default = OFF
Selections are: ON, OFF
Allows enabling/disabling of TxFlow control.
Slot = n
Identifies the slot number for the specific
adapter currently being configured. This
parameter is not necessary if only a single
adapter is installed.
Speed = n
If link negotiation has been disabled, specifies
port speed to be either Auto, 10HD or 10FD,
100HD or 100FD.