Filter
Top Products
2-16
Installing the Access Point 530
Installation Procedures
Installing the
Access Point 530
Note: As indicated in the following table, some of the wires should not
be connected. If you do connect the wires that are labeled “Reserved”,
you might get unexpected results with some terminals.
Serial interface signal directions
2. Turn on the terminal or PC’s power and, if using a PC, start the PC terminal
program.
3. Enter admin at the Username: prompt, and admin at the Password: prompt.
You will then see the access point console command (CLI) prompt, for
example:
ProCurve Access Point 530#
If you want to continue with console management of the access point at this
time, see chapter 3, “Getting Started With Access Point Configuration” for
some basic configuration steps. For more detailed information, refer to the
Management and Configuration Guide.
DB-9 (DTE)
Access Point 530
DB9 (DTE)
Terminal or PC
DB-9 (DTE)
Access Point 530
DB-25 (DTE)
Terminal or PC
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
8
3
2
20
7
6
4
5
22
Reserved
Reserved
Reserved
Reserved
GND
Reserved
Reserved
Reserved
Reserved
GND