Filter
Top Products
IP Routing Features
Configuring OSPF
OSPF Interface Status for 10.3.18.36
IP Address : 10.3.18.36 Status : enabled
Area ID : 10.3.16.0
State : BDR Auth-type : none
Cost : 1 Priority : 1
Type : BCAST
Transit Delay : 1 Retrans Interval : 5
Hello Interval : 10 Rtr Dead Interval : 40
Designated Router : 10.3.18.34 Events : 3
Backup Desig. Rtr : 10.3.18.36
Syntax: show ip ospf interface [vlan <vlan-ID> | <ip-addr>]
The OSPF interface display for a specific VLAN or IP address has the same
information as the non-specific show ip ospf interface command for the IP
Address, Area ID, Status, State, Auth-type, Cost, and Priority fields. See the
information for the general command above for definitions of these fields.
The show ip ospf interface command for a specific VLAN or IP address shows
the following additional information:
Table 16-7. CLI Display of OSPF Interface Information – VLAN or IP Address
This Field... Displays...
Type
Will always be BCAST for interfaces on this routing
switch. Point-to-point or NBMA (frame relay or ATM)
type interfaces are not supported on HP Procurve Series
5300XL Switches.
Transit Delay
Configured transit delay for this interface.
Retrans Interval
Configured retransmit interval for this interface.
Hello Interval
Configured hello interval for this interface.
Rtr Dead Interval
Configured router dead interval for this interface.
Designated
Router
IP address of the router that has been elected designated
router on this interface.
16-58