Filter
Top Products
IP Routing Features
Configuring OSPF
Displaying OSFPF Redistribution Information
As described under “Enable Route Redistribution” on page 16-49, you can
configure the routing switch to redistribute connected and static routes into
OSPF. When you redistribute a route into OSPF, the routing switch can use
OSPF to advertise the route to its OSPF neighbors.
To display the status of the OSPF redistribution, enter the following command
at any CLI context level:
HPswitch# show ip ospf redistribute
OSPF redistributing
Route type Status
---------- --------
connected enabled
static enabled
The display shows whether redistribution of each of the route types,
connected and static is enabled.
Displaying OSFPF Redistribution Filter (restrict)
Information
As described under “Define Redistribution Filters” on page 16-47, you can
configure the redistribution filters on the routing switch to restrict route
redistribution by OSPF.
To display the status of the OSPF redistribution filters, enter the following
command at any CLI context level:
HPswitch# show ip ospf restrict
OSPF restrict list
IP Address Mask
--------------- ---------------
10.0.8.0 255.255.248.0
15.0.0.0 255.0.0.0
This display shows the configured restrict entries.
16-63