Filter
Top Products
Hardware options installation 46
7.
Install the DIMM.
8. Install the air baffle (on page 25).
9. Install the access panel (on page 21).
10. Install the server into the rack ("Installing the server into the rack" on page 31).
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server (on page 19).
Use RBSU ("HP ROM-Based Setup Utility" on page 72) to configure the memory mode.
For more information about LEDs and troubleshooting failed DIMMs, see "Systems Insight Display LED
combinations (on page 9)."
Hot-plug hard drive options
When adding hard drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one hard drive is used, install it in the bay with the lowest device number.
• Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
Removing a hot-plug SAS or SATA hard drive
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
1. Determine the status of the drive from the hot-plug SAS hard drive LED combinations ("Drive LED
definitions" on page 15).
2. Back up all server data on the drive.