Filter
Top Products
EN
Step 7: Loading the Input Trays
29
Loading media in the optional
tray 4
Note
Before loading media into tray 4, verify
that the spacers were removed from the
tray when “Step 2: Unpacking the
Printer” was performed.
1
Firmly grip the handle in the center of
the input tray, squeeze the release
lever, and pull the tray out until it
stops.
Depending on your country, tray 4
arrives adjusted for either A4- or letter-
sized media. To load A4- or letter-sized
media, proceed to step 5; otherwise,
continue with step 2.
2
Adjust the front guide by pulling up on
the pin (A), placing the guide into the
slots on the top and bottom of the tray
that correspond to the media size you
are loading (B), and pushing in the
pin.
3
Repeat step 2 to adjust the back
guide.
4
Repeat step 2 to adjust the left media
guide.
Note
To load 11-by-17 inch media, rotate the
left media guide 90
°
, move it to the back
of the tray, and place it into the slots on
the top and bottom of the tray that
correspond to 11-by-17.