Filter
Top Products
Error Messages
125Embedded Web Server User Guide
Error 79: FRU Failed The specified FRU has
failed.
Consult the
installation/service
manual for appropriate
action.
Error 81: Default Zone
Enabled
The request cannot be
completed because the
default zone is enabled
Disable the default zone
and resubmit the
command.
Error 82: Invalid Interop
Mode
The value entered for the
interoperability mode is
not valid.
The interoperability mode
for the director or switch
must be mcdata
(Homogenous Fabric) or
open (Open Fabric 1.0).
Make the appropriate
changes and resubmit the
command.
Error 83: Not Allowed in
Open Fabric Mode
This request cannot be
completed while this
switch is operating in
Open Fabric 1.0 mode.
Configure the interop
mode to Homogenous
Fabric mode.
Error 88: Invalid Feature
Key Length
The feature key installed is
longer than the maximum
length allowed.
Be sure that the key has
been entered correctly
and resubmit. Contact
your sales representative
with any further problems.
Error 89: Not Allowed in
S/390 Mode Without the
SANtegrity Feature
Cannot configure port
types in S/390 mode
(FICON management
style in HAFM) without
installing SANtegrity.
This command is only
supported when the
switch is in Open Systems
mode (Open Systems
management style in
HAFM) or in S/390
mode (FICON
management style in
HAFM) with SANtegrity.
Error 90: Invalid Port Type The port type configured
is invalid.
A port may be configured
to be an eport, gport, or
fport. Be sure the port is
configured appropriately
and resubmit the
command.
Table 9: Embedded Web Serve Messages (Continued)
Message Description Action