Filter
Top Products
Configuring Zones
60 Embedded Web Server User Guide
Naming Conventions for Zones and Zone Sets
The following naming conventions apply to zones and zone sets:
■ All names must be unique and may not differ by case only. For example,
myzone and MyZone are both valid individually, but they are not unique.
■ The first character of a zone set name must be a letter (A-Z, a-z).
■ A zone set name cannot contain spaces.
■ Valid characters are a-z, A-Z, 0-9, ^, -, _, and $.
■ A zone set name can have a maximum of 64 characters.
Zones
A zone contains a set of members that can access each other. Refer to Table 3 on
page 64 for details on the number of members that you can configure in a zone
and the number of zones that you can configure with the EWS Configure Zone
functions.
A zone member can be a switch or director port or the WWN of the device. Ports
and devices spread throughout multiple managed products in a multiswitch fabric
may be grouped into the same zone. Members of a zone can see each other;
members in different zones cannot. The number of members that you can
configure for a zone varies according to the number of zones in the zone set, the
length of the zone names, and other factors, but is essentially bounded by the
available nonvolatile random-access memory (NVRAM) in the managed product.
Note: Port numbers cannot be used for zone members if the interoperability mode for
the switch or director is set to Open Fabric 1.0 mode. In this case, you must use node
WWNs as zone members.
The type of zone members identified for a zone may be mixed and matched. For
example, two members may be specified by a port number and the third member
by the WWN of the device.
Using WWNs
To identify a zone member by WWN, use the 16-digit WWN of the device. For
example:
10:00:08:00:88:40:C0:D4