Filter
Top Products
Installation procedure
To install the HBA:
1. Check the mo
therboard and make any necessary configuration changes to accommodate the HBA.
2. Power down t
he
peripherals, and then turn off the computer.
3. Disconnect the power cable.
4. Remove the computer cover and save the screws.
5. Locate the
appropriate bus slot. The connector for the slot looks like the connector in Figure 1.
Figure 1PCI-X 2.0connector
6. Remove theslotcover forthe slot in whichyou will installthe HBA.
7. Place the HBA in the slot and carefully press the board into the slot until it seats firmly.
8. Secure the H BA to the chassis following the server manufacturer’s instructions.
9. Connect the appropriate cable from the devices to the corresponding LC-connector.
10. Close and tighten the computer cover.
11. Plug in the power cable.
12. Power up all external FC devices, then power up the server and observe the m onitor and the LED
indicators described in "LED indicators " on page 15 to ensure proper operation.
14
Installing the HBAs