Filter
Top Products
Removal and replacement procedures 29
6.
Remove the hard drive backplane. Use the backplane retainer to disengage the hard drive
backplane from the connector.
To replace the component:
1.
Install the hard drive backplane. Press down on the hard drive backplane retainer to seat the board.
2.
Install the hard drives ("Hard drive" on page 26).
3.
Install the hard drive blanks ("Hard drive blank" on page 25).
4.
Install the access panel ("Access panel" on page 25).
5.
Install the server blade.
Hard drive backplane retainer
To remove the component:
1.
Power down the server blade (on page 24).