Filter
Top Products
Removal and replacement procedures 35
To replace the component, reverse the removal procedure.
Heatsink
To remove the component:
1.
Power down the server blade (on page 23).
2.
Remove the server blade (on page 23).
3.
Remove the access panel ("Access panel" on page 24).
4.
To replace heatsink 3 or 4, perform these additional steps:
a.
Remove all hard drives ("Hard drive" on page 25), if installed.
b.
Remove the SAS controller ("SAS controller" on page 29), if installed.
c.
Remove the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on
page 33).
5.
Remove the failed heatsink.
To replace the component:
1.
Clean the old thermal grease from the processor with the alcohol swab. Allow the alcohol to
evaporate before continuing.