Filter
Top Products
Removal and replacement procedures 33
4. Lift the left side of the device bay shelf to disengage the three tabs from the divider wall, and then
remove it from the enclosure.
To replace the component, reverse the removal procedure.
Half-height or full-height blade
CAUTION: This procedure provides instructions for replacement of a failed part only. To
change the configuration of components, see the appropriate HP BladeSystem c-Class
enclosure setup and installation guide.
To remove the component:
1. Identify the proper half-height or full-height blade in the enclosure ("Device bay numbering" on page
56).
2. Back up all data.
3. Power down the half-height or full-height blade ("Power down the server blade" on page 29).
4. Remove the blade: