Filter
Top Products
Removal and replacement procedures 47
17. Remove the two slotted T-15 Torx screws that secure the interconnect board.
18. Remove the interconnect board.
To replace the component, reverse the removal procedure.
Insight Display signal pass-thru board
WARNING: To reduce the risk of damage to the midplane and component connectors, always
remove or disengage and extend all blades and power supplies 7.62 cm (3 in) before
removing or installing the rear cage.
To remove the component:
1. Power down the server blades ("Power down the server blade" on page 29).
2. Power down the enclosure (on page 30).
3. Disconnect all cables.