Filter
Top Products
Removal and replacement procedures 45
e. Use the handholds to extend and remove the rear cage from the enclosure.
To replace the component, reverse the removal procedure.
Insight Display front-to-rear interconnect board
WARNING: To reduce the risk of damage to the midplane and component connectors, always
remove or disengage and extend all blades and power supplies 7.62 cm (3 in) before
removing or installing the rear cage.
To remove the component:
1. Power down the server blades ("Power down the server blade" on page 29).
2. Power down the enclosure (on page 30).
3. Disconnect all cables.
4. Remove the half-height and full-height blades ("Half-height or full-height blade" on page 33).
5. Remove the device bay blanks ("Device bay blank" on page 31).
6. Remove the power supplies and power supply blanks ("HP BladeSystem c7000 power supply or
power supply blank" on page 30).
7. Remove the fans ("Active Cool fan" on page 37).
8. Remove the fan blanks ("Fan blank" on page 36).
9. Remove the interconnect switches and Pass-Thru modules ("Interconnect switch or Pass-Thru module"
on page 38).
10. Remove the interconnect blanks ("Interconnect blank" on page 37).
11. Remove the Onboard Administrator tray ("Onboard Administrator tray" on page 41).
For this procedure, you can remove the Onboard Administrator tray with the Onboard Administrator
modules or blanks installed.
12. Remove the rear cage ("Rear cage" on page 43).
WARNING: To reduce the risk of personal injury or equipment damage, at least two people
are needed to safely move the rear cage.