Filter
Top Products
Manually configure IPv6 TCP/IP parameters from the control panel
Use the control-panel menus to manually set an IPv6 address.
1. Press the Home button
.
2. Open each of the following menus. Press the down arrow
to highlight it and then press the OK
button to select it.
a. CONFIGURE DEVICE
b. I/O
c. EMBEDDED JETDIRECT MENU
d. TCP/IP
e. IPV6 SETTINGS
f. ADDRESS
g. MANUAL SETTINGS
h. ENABLE
i. ON
j. ADDRESS
3. Press the up arrow
or the down arrow to select the first character of the address. Press the
OK button.
Repeat this process for each character in the address.
NOTE: You must press the OK button after entering each character.
4. Press the up arrow or the down arrow to select the stop character . Press the OK button.
5. Press the Home button
to return to the Ready state.
76 Chapter 5 Connect the product ENWW