Filter
Top Products
Hardware options installation 54
9. If removed, install the BBWC battery pack or the FBWC capacitor pack.
10. Install the access panel (on page 26).
If you are installing DIMMs in online spare, mirrored, or lock-step configuration, configure this mode in RBSU
("HP ROM-Based Setup Utility" on page 72).
For more information about LEDs and troubleshooting failed DIMMs, see "Systems Insight Display LED
combinations (on page 10)."
Hot-plug SAS hard drive options
When adding hard drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one hard drive is used, install it in the bay with the lowest device number.
• Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
Installing a hot-plug SAS hard drive
1. Remove the SAS hard drive blank.
2. Prepare the hard drive.