HP (Hewlett-Packard) 6980 Printer User Manual


 
Solution
In order for the printer to be usable on a network on which computers are protected by
a software firewall, you must do the following:
1. Temporarily disable the software firewall before installing the printer software on
a computer.
2. Assign the printer a static IP address.
Temporarily disabling the software firewall before installation
Before assigning the printer a static IP address and then installing the printer software
on a computer, temporarily disable the software firewall on the computer. For
instructions about disabling the software firewall, see the documentation that came
with the software firewall.
Whenever the software firewall is disabled, HP strongly recommends that the
following items be installed on the computer:
A hardware device, such as a gateway, that provides firewall protection between
the computer and the Internet
An up-to-date anti-virus software program
For maximum virus protection while the firewall is disabled, disconnect the computer
or router from the Internet while you install the printer software on the computer. After
the printer software is installed, you can reconnect the computer or router to the
Internet.
After disabling the software firewall, follow the steps for assigning the printer a static
IP address.
Assign the printer a static IP address
Get ready
Before assigning the printer a static IP address, you must find the following
information about the network:
The IP address range of the network DHCP server
Subnet mask
Gateway
To find this information, see the configuration utility for the network router or switch.
Otherwise, see the documentation that came with the network router or switch.
The static IP address must be outside the range of IP addresses that the network
assigns to devices on the network.
For example, a network might use DHCP to assign IP addresses that range from
10.0.0.1 to 10.0.0.100. In this case, 10.0.0.25 would not be a good static IP address to
assign to the printer since it falls in the range of IP addresses assigned by the
network. However, 10.0.0.101 would be a good static IP address because it falls
outside the range of IP addresses assigned by the network.
Network Guide
9