Filter
Top Products
Installing the Memory Module
15HP StorageWorks ESL9000 Series Tape Library Memory Module Upgrade Guide
Completing the Procedure
Completing the memory module installation procedure consists of the following
steps:
■ Turning the Library On
■ Initializing Non-Volatile RAM
■ Setting the Library for HP Mode
■ Changing the Library Settings
■ Setting the Number of Tape Drives
■ Calibrating the Library
Turning the Library On
To turn on the library:
1. Turn on the main circuit breaker switch (CB1) on the AC distribution
assembly. If two AC distribution assemblies are installed, turn on CB1 on
each assembly.
Note: The AC power distribution assembly is located in the lower left part of the
cabinet base, behind the rear access panel.
2. Close the library doors.
3. Turn on the power switch, located below the GUI.
The GUI lights and displays Power-Up. After a few seconds, it displays either
Initializing for On-line or System Off-line, depending upon the setting of
the Power-On State option.
4. If the GUI displays Initializing for On-line, press the Stop button, the
Standby button, and then the Stop button again to place the library off-line.
Caution: Do NOT let the robot initialize. Press the Stop and Off-line buttons
immediately after power-on.
When the library finishes going off-line, the GUI displays System Off-line.