Filter
Top Products
Installing the Memory Module
16 HP StorageWorks ESL9000 Series Tape Library Memory Module Upgrade Guide
5. If the HP or Compaq screen is displayed, continue to “Initializing
Non-Volatile RAM” on page 16. If the HP or Compaq screen is not displayed,
proceed to “Setting the Library for HP Mode” on page 16.
Initializing Non-Volatile RAM
To initialize non-volatile RAM:
1. Press the Service tab on the GUI.
2. If prompted, enter the Service password and press Enter. The GUI displays
the Service screen.
Note: The default Service password is 5678.
3. Press the Initialize Nonvol Config button.
4. Press the Continue button when prompted.
The library initializes non-volatile memory.
5. Proceed to “Changing the Library Settings” on page 18.
Setting the Library for HP Mode
If the library does not display the HP or Compaq screen after completing the steps
under “Turning the Library On” on page 15, use the following procedure to set the
library for HP mode. The Libdiag utility is used in this procedure. For details on
using this utility, refer to the StorageWorks by Compaq ESL9000/TL800 Series
Tape Library Diagnostic Software Guide, available from
http://www.hp.com/support
.
Starting Libdiag
To start Libdiag:
1. Connect a PC to the library diagnostic port using a RS-232 cable.
2. Make sure that the library is in the stand by mode.
3. Double-click the diagnostic icon.
4. Select 9600 baud.
5. Select the appropriate Com port (default is com1).