Filter
Top Products
Hardware options installation 61
7.
Install the tape drive.
8. Connect the power cable to the rear of the drive.
9. Connect the USB tape drive cable to the rear of the drive and to the USB tape drive connector on the
system board.
10. Remove the applicable bezel blank from the bezel ("Remove a bezel blank" on page 24).
11. Install the access panel (on page 22).
12. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
13. Power up the server (on page 20).
Full-height tape drive option
For clarity, the following illustrations include option cabling only.