Filter
Top Products
Removal and replacement procedures 33
Tower configuration panels
To remove the component:
1. Power down the server (on page 29).
2. Remove the tower feet ("Feet" on page 32).
3. Remove the tower configuration panels:
a. Use the T-10/T-15 Torx screwdriver to remove the two front panel screws.
b. Remove the tower configuration panels.
To replace the component, reverse the removal procedure.
Rack rails
NOTE: This procedure applies to rack servers only.
To remove the component:
1. Power down the server (on page 29).
2. Remove the server from the rack (on page 29).
3. Pull the rack rail latch.
4. Slide the rail to the front of the server to release the rail.