Filter
Top Products
Removal and replacement procedures 40
To replace the component, reverse the removal procedure.
Expansion board
CAUTION: To prevent damage to the server or expansion boards, power down the server and remove all
AC power cords before removing or installing the expansion boards.
To remove the component:
1. Power down the server (on page 29).
2. Extend the server from the rack, if applicable ("Extend the server from the rack" on page 29).
3. Remove the access panel ("Access panel" on page 31).
4. Disconnect any cables attached to the expansion board.
5. Release the retainer clip.
6. Press the slot release lever and swing the slot release lever upward.
7. Remove the expansion board.