Filter
Top Products
Removal and replacement procedures 44
4.
Slide the media latch to release the drive and extend the drive from the bay to access the cabling.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
5. Disconnect the data and power cables from the device.
6. Remove the half-height or full-height drive.
To replace the component, reverse the removal procedure.
Systems Insight Display
To remove the component:
1. Power down the server (on page 29).
2. Do one of the following:
• Unlock and remove the bezel ("Front bezel" on page 30).
• Extend the server from the rack (on page 29).
3. Remove the access panel ("Access panel" on page 31).