Filter
Top Products
13
MSSC, LLC Collinsville, IL USA Tel: 618-343-1006 Fax: 618-343-1016 55899 Rev 18210
www.msscllc.com
Common Parameters set at Factory
MSG = COMMON
DELAY = 000 mm
WIDTH = 08 mm
HEIGHT = 13 mm
DENSITY = 4
FONT = FONT 2
DIRECT = ←ABC
SPEED = 30.5 m/min
DT Tune
The DT Tune sub menu is where adjustments to date code formatting are made. The settings in this
menu apply to all messages printing dates.
• MX SIZE: Sets the number of characters in month code. For a value of 2, a two digit number
corresponding to the month is printed. For a value of 3, the three letter abbreviation for the
month is printed
• DT TRIM: Sets how month and day characters with leading zeros are printed. There are three
options
o 2007.01.01: Prints leading zeros in day and month.
o 2007. 1. 1: Replaces leading zeros with spaces as place holders.
o 2007.1.1: Prints month and day with no leading zero or space.
DT TRIM is not available when MX SIZE is set to 3.
Total Count
Total count shows how many times the photo eye has triggered printing since the last time the count was
reset. The count can be reset here by selecting YES and pressing ↵.
Init Data
The INIT DATA function ERASES ALL DATA except TOTAL COUNT and S/N. Once this is done
any lost data cannot be recovered.
To initialize all data:
1. Press STUP key
2. Select INIT DATA and press ↵.
3. Select Yes and press ↵.
Extend
The EXTEND sub menu contains advanced printing and setup functions that change the way the QM2
prints.
• RPEAT JET:
o REPEAT: Sets the number of times the message is repeated. “CONTINUE” repeats the
message while the photo eye is activated.
o INTERVAL: Sets the spacing between prints.
o S/N COUNT: “COUNT” changes the serial number each time the message is printed.
“HOLD” changes the serial number with each activation of the photo eye.