Filter
Top Products
Figure 6-45 Aligning the Dual Processor Module
7. Use the special processor tool to lock the dual processor module in place on the system
board. To do this, insert the special processor tool into the hole that runs down the side of
the heatsink and rotate it clockwise 180 degrees (Figure 6-46).
Figure 6-46 Locking the Dual Processor Module in Place
8. Slide the sequencing retainer plate toward the front of the server.
9. Screw in the four heatsink captive screws in a crisscross torquing pattern by alternately
tightening the screws so as not to completely tighten one screw before the others.
Removing and Replacing a Dual Processor Module 161