*%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%*
*
*
* RTE–A Sample System Generation Answer File
*
* ***********************************************************************
* * *
* * This half of the Primary answer file is designed to be edited *
* * and used for a system–specific generation. To use this file, *
* * first delete the first half of this file, then uncomment the *
* * required lines (marked with a ”*!”) and any specific system *
* * modules required by removing the appropriate comment character. *
* * *
* * For further information, refer to the RTE–A System Generation *
* * and Installation Manual, part no. 92077–90034. *
* * *
* * 1. Uncomment all required modules by removing the string *
* * ”*!REMOVE!”. Refer to the EDIT/1000 User’s Guide, part no. *
* * 92074–90001, and the note at the bottom of these instructions *
* * for information on how to use EDIT/1000 to edit this file. *
* * *
* * 2. To select your system disk, remove *!REMOVESCSI! for SCSI *
* * disk, remove *!REMOVEHPIB! and *!REMOVEHPIB64! for 64MB HP–IB *
* * disk, or remove *!REMOVEHPIB! and *!REMOVEHPIB20! for 20MB *
* * HP–IB disk. *
* * *
* * 3. If you want VC+ in your system, uncomment all VC+ modules *
* * by removing the string ”*!YESVC+!”; otherwise uncomment *
* * the non–VC+ modules by removing the string ”*!NO_VC+!”. *
* * VC+ is supplied with the HP 92078A Virtual Code+ package, *
* * a product which allows a multiuser environment and spooling. *
* * *
* * 4. If you have NS/1000 and LAN/1000 in your system, uncomment *
* * all NS/1000 and LAN/1000 modules by removing the string *
* * ”*!YES_NS!”; otherwise, uncomment the non–NS modules by *
* * removing the string ”*!NO__NS!”. If you have NS/1000 but not *
* * LAN/1000 in your system, refer to the NS subsystems’ answer *
* * file. *
* * *
* * 5. If you have APRA/1000 in your system, rename the ”NS1000” *
* * directory to ”APRA1000” and comment the %adv00 driver and LU *
* * mapping (lu 81 – 82) out. *
* * *
* * 6. If you do not use an ASIC card as LU 1 (as generated in *
* * this system) comment it out and change one of the *
* * terminal LUs generated into the system (such as the *
* * 8–channel multiplexer) as LU 1. *
* * *
* * 7. Uncomment the ”*” before the RPL file you will be using *
* * according to your hardware configuration. If you are using *
* * the A600 (not the A600+), i.e., %RPL60, you will need to *
* * remove the string ”*!RPL60_!”. If you are using the A900 and *
* * NS/1000, choose %RPL91 then either rpl_a900_rev4.rel (rev.4 *
* * firmware or later) or xmb.rel (pre rev.4 firmware). *
* * *
* * 8. If you don’t have NS/1000 in your system and you want to use *
* * the DDC00/DDC01 modem handler, HPMDM.RUN, uncomment the *
* * ”*!YES_NS!” before HPMDM_TABLE.REL. If you want to save *