Filter
Top Products
* Table Generation phase – configure LU tables
*
*
* HP–IB #1 –– High speed disk interface bus Select Code = 27b
* SCSI #1 –– SCSI disk/DAT tape interface bus
*
*!REMOVEHPIB!ift,/rte_a/%Id*37,SC:27B
*
*!REMOVESCSI!ift,/rte_a/idq35.rel,SC:27B
*
* SCSI DAT tape LU 14
* SCSI 7980S LU 5
*
*!REMOVESCSI!dvt,/rte_a/ddq24_gen.rel,,lu:14,dp:1:3
*!REMOVESCSI!dvt,/rte_a/ddq24_gen.rel,M7980,lu:5,dp:1:4
*
* SCSI hard disk
*
*!REMOVESCSI!dvt,/rte_a/ddq30_gen.rel,m64mb:0,lu:10,dp:1:6 dp:8:1
*!REMOVESCSI!dvt,/rte_a/ddq30_gen.rel,m64mb:1,lu:11,dp:1:6 dp:8:1
*
* SCSI 650A MO disk
*
*!REMOVESCSI!dvt,/rte_a/ddq30_gen.rel,m64mb:0,lu:12,dp:1:5 dp:8:3
*!REMOVESCSI!dvt,/rte_a/ddq30_gen.rel,m64mb:1,lu:13,dp:1:5 dp:8:3
*
* SCSI floppy single sided LU 50
*
*!REMOVESCSI!dvt,/rte_a/ddq30_gen.rel,m16mb:0,lu:50,dp:1:0:0:0:0:0,–
*!REMOVESCSI! dp:6:66:16:0
*
* SCSI floppy double sided LU 51
*
*!REMOVESCSI!dvt,/rte_a/ddq30_gen.rel,m16mb:0,lu:51,dp:1:0:0:0:0:0,–
*!REMOVESCSI! dp:6:154:16:0
*
*
* ###################################################################
* # #
* # The bus controller dvt is needed only if Direct I/O to the #
* # device is being done. #
* # #
* ###################################################################
*
* Bus Controller LU HP–IB address 36b
* LU 15
*
*!REMOVEHPIB!dvt,,,LU:15,TO:2000,DT:37B,TX:0,DX:1,DP:1:36B,PR:0
*
* HP–IB disk HP–IB address 0
* LU 18–19
*
*!REMOVEHPIB!dvt,/rte_a/%dd*33,M7908_CF:0,LU:18,DP:1:0,–
*!REMOVEHPIB! DP:2:0:0:00:0:4096 DP:7:64
*!REMOVEHPIB!dvt,/rte_a/%dd*33,M7908_CF:0,LU:19,DP:1:0,–
*!REMOVEHPIB! DP:2:0:0:04:0:4096 DP:7:64
*
*