Filter
Top Products
* A900 pre rev.4 firmware only
*re /rte_a/xmb.rel,mb01 For %envrn with A900 pre rev.4 firmware only
*re /rte_a/xmb.rel,mb10 For %envrn with A900 pre rev.4 firmware only
*re /rte_a/xmb.rel,mb21 For %envrn with A900 pre rev.4 firmware only
*
*!REMOVE!re /rte_a/%exec,, EXEC request processing
*!REMOVE!re /rte_a/%rtioa,, Real–Time I/O control
*!REMOVE!re /rte_a/%iomod,, I/O module
*!REMOVE!re /rte_a/%maps,, Dynamic mapping system routines
*!REMOVE!re /rte_a/%progs,, Program state processing
*!REMOVE!re /rte_a/%util,, System variables and utilities
*!REMOVE!re /rte_a/%sam,, System available memory
*!REMOVE!re /rte_a/%sched,, Programmatic program scheduling
*!REMOVE!re /rte_a/%strng,, Runstring passing
*!REMOVE!re /rte_a/%erlog,, Error logging
*!REMOVE!re /rte_a/%opmsg,, Operating system messages
*!REMOVE!re /rte_a/%sycom,, Operator commands
*!REMOVE!re /rte_a/%id*43,, Power–fail driver
*!REMOVE!re /rte_a/%$IDRPL,, System ID dup IDRPL
*!REMOVE!re /rte_a/%signl,, Signal processing module
*!YESVC+!re /vcplus/secos.rel,, Security/1000 module
*!YESVC+!re /vcplus/check.rel,, Security/1000 module
*!YESVC+!re /vcplus/%spool,, Spooling module
*
*
* #################################################################
* # #
* # If you are using an A600 (not an A600+) WITHOUT CDS, then #
* # the following paragraph applies. If you are using any #
* # other type of A–Series processor, (A400 with or without #
* # CDS, A600+, A700 or A900) then the following paragraph #
* # does NOT apply. #
* # #
* # The two routines .DMP and .DDI must be relocated here #
* # because they are required by code that is in the O.S. #
* # partitions. You cannot do library searches for code in #
* # O.S. partitions. This is required ONLY when using an #
* # A600 (using %RPL60). If you are using any other RPL, #
* # these modules will cause duplicate entry point errors #
* # if included in the generation. #
* # #
* #################################################################
*
*!RPL60_!re /rte_a/$math,.dmp Required for A600 (not A600+) (RPL60)
*!RPL60_!re /rte_a/$math,.ddi Required for A600 (not A600+) (RPL60)
*
*!REMOVE!se /rte_a/$syslb,, Search the system library
*
* define partitionable modules
*
*!REMOVE!pa perr,xcmnd,stat,dsq,vema,lock,load,memry,iorq
*!REMOVE!pa time,class,abort,alarm
*!YESVC+!pa cdsfh,envrn
*!YES_NS!pa nsabp
*
* #################################################################
* # #
* # If you want to include the dummy version of a partitionable #