Filter
Top Products
1-6
Introducing the ProCurve Series 8200zl Switch
Front of the Switch
Introducing the ProCurve
Series 8200zl Switch
Figure 1-5. System Support Module LEDs
Table 1-3. System Support Module LEDs
These LEDs are located on the System Support Module.
SSM
(green/orange)
On green The communication link with the SSM (system support module) is good.
Off
The communication link with the SSM is bad or there is no SSM installed.
Blinking
orange
1
The communication link with the SSM is bad or the SSM itself has failed.
Module Status LED On green The Management Module is active and has passed all self-tests.
Blinking
orange
1
If Module Status, Fault and Self Test LEDs are blinking, this MM has failed self-test
If Module Status and Fault LEDs are blinking, an operational fault has occurred.
MM State LEDs
(green)(
Actv Indicates the Management Module is active and is the primary management
module.
Stby Indicates that this Management Module is the standby management module.
Dwn Indicates that this Management Module has been shutdown.
1
The blinking behavior is an on/off cycle once every 1.6 seconds, approximately.
2
The blinking behavior is an on/off cycle once every 0.5 seconds, approximately.
LED State Meaning
Test
(green/orange)
Off The normal operational state; the switch is not undergoing self test.
On green The switch self test and initialization are in progress after you have power cycled
or reset the switch. The switch is not operational until this LED goes off. The Self
Test LED also comes on briefly when you “hot swap” a module into the switch
and the module is automatically self tested.
Blinking
orange
1
The port has failed self test. The switch Fault, Self Test LEDs, and appropriate
module status LEDs will flash simultaneously.