Filter
Top Products
5. WEP Security: Select the data privacy algorithm you want. Enabling the security
can protect your data while it is transferred from one station to another. The
standardized IEEE 802.11 WEP (64-bit or 128-bit) is used here.
6. WEP Key 1, 2, 3 & 4: After enable the 64-bit or 128-bit WEP key security, please
select one WEP key to be used in default setting and then input 10 or 26 hex-
decimal (0-9, A-F) digits.
7. MAC Access Control: Setup MAC addresses to control which wireless clients
can associate to the wireless LAN and this device or connect to this device.
Figure 3.5
MAC Address Control allows only client devices with specified MAC
addresses to associate and pass data through this device.
MAC Address Control
Check “Enable” to enable the “MAC Address
Control”. All of the settings in this page will take
effect only when “Enable” is checked.
Connection control
Check "Connection control" to enable the controlling
of which wired and wireless clients can connect to
this device. If a client is denied to connect to this
device, it means the client can't access to the Internet
either. Choose "allow" or "deny" to allow or deny the
clients, whose MAC addresses are not in the "Control
table" (please see below), to connect to this device.
9